Way too much else going on but one good consideration of 3D printing I had not previously thought much about is the “print-n-play” aspect of the…hobby? After deciding I wanted to experiment a bit more with my printer I spent a kinda short amount of time finding a free model to print. Total print time was listed as 1hr+14min so I started the job and left for errands. Upon return the results are again decent with just a little clean up required.
This “Satellite with Flexible Legs” will look good in my office. Really thinking about adding some googly eyes to it…
Feature image courtesy RMN
The opinions and views expressed in this blog are those of the author alone and are presented in a personal capacity. They do not necessarily represent the views of U.S. Navy or any other U.S. government Department, Service, Agency, Office, or employer.
RockyMountainNavy.com © 2007-2026 by Ian B is licensed under CC BY-SA 4.0
Rocky Mountain Navy Gamer 